Kenwood 50 MHZ ALL MODE TRANSCEIVER TS-590S - Manual (Page 59)

8 EXPANSIVE APPLICATION SOFTWARE
TS-590S CONTENTS 53
The microphone connected to the TS-590S and the transceiver’s built-in speaker are used.
The microphone and speaker connected to a PC are used. The ACC2 connector is used for input/
output of the TS-590S’s audio signal.
Caution: To use the ACC2 connector for input/output of the audio signal, ARUA-10 is not required.
The microphone and speaker connected to the PC are used. The USB connector is used for input/
output of the TS-590S’s audio signal.
8.2.2 Controlling TS-590S from a PC using the USB Connector
PC
Type of
Connection
TS-590S
Software Hardware Hardware
Control signal
Virtual COM port
driver and
ARCP-590
- USB cable * Connected to the USB connector
Audio signal - - No connection
The microphone connected to the
TS-590S and the transceiver’s built-in
speaker
8.2.3 Controlling TS-590S from a PC using the COM and ACC2
connectors (microphone and speaker connected to the PC to
be used)
PC
Type of
Connection
TS-590S
Software Hardware Hardware
Control signal ARCP-590 - RS-232C cable * Connected to the COM connector
Audio signal -
The microphone
and speaker
connected to the
PC
Home-made
audio cable
* Connected to the ACC2 connector
8.2.4 Controlling TS-590S from a PC using the USB connector
(microphone and speaker connected to the PC to be used)
PC
Type of
Connection
TS-590S
Software Hardware Hardware
Control signal
Virtual COM port
driver and
ARCP-590
-
USB cable * Connected to the USB connector
Audio signal
Windows
standard driver
and ARUA-10
The microphone
and speaker
connected to a
PC