Kenwood 50 MHZ ALL MODE TRANSCEIVER TS-590S - Manual (Page 33)

4 DSP
TS-590S CONTENTS 27
For the demodulation of the RX signal in SSB, CW, FSK and SSB-DATA modes, we have employed
the proven PSN (Phase Shift Network) design again.
In the previous models (TS-2000S and TS-870S), the selection of the PSN’s characteristics was
interlocked with the passband setting of the IF filter, and when the passband is narrow, a PSN with a
good sideband suppression was selected.
On the other hand, on the TS-590S, the order of the PSN is decreased by tuning the PSN only to the
opposite side band that was not fully removed by the digital IF filter.
In this way, the low frequency range of the PSN stretches out substantially and the poor group delay
characteristics in the lower frequency range, which is a drawback of a PSN, is also improved. As a
result, the low range reaches farther with less attenuation than that reached in the previous models.
In SSB mode, the digital IF filter has a setting of “0 Hz” in LO CUT and this means the cutoff
frequency is set to the carrier point so that the low frequency range can be stretched out maximally.
Enjoy distinctly different audio from that of previous transceivers.
The same demodulation process is used in SSB, CW FSK and SSB-DATA modes, except that the
selection of PSN characteristics and of digital IF filters varies depending on the mode.
In AM mode, an absolute value detection circuit is used for demodulation as in the previous models.
4.4 Demodulation