Kenwood TM-271A - Manual (Page 42)

35
7
CALL CHANNEL
Call Channel default settings:
• On K and M market models, pressing [CALL] changes the
transceiver to the Call Channel.
• On E market models, pressing [CALL] causes the
transceiver to transmit a 1750 Hz tone {page 25}.
The Call Channel can be recalled instantly no matter
what frequency the transceiver is operating on. For
instance, you may use the Call Channel as an
emergency channel within your group. In this case, Call
Scan {page 43} will be useful.
The default Call Channel frequency is 144.000 MHz.
Note: Unlike Memory Channels 0 to 199, the Call Channel cannot be
cleared.
R
ECALLING THE
C
ALL
C
HANNEL
1 Press [CALL] to recall the Call Channel.
• The Call Channel frequency and “C” appear.
• To return to the previous frequency, press [CALL] again.
R
EPROGRAMMING THE
C
ALL
C
HANNEL
1 Select your desired frequency and related data (Tone,
CTCSS, DCS, or offset direction, etc.).
• When you program the Call Channel as an odd-split
channel, select a reception frequency first.
2 Press [F].
• A Memory Channel number appears and blinks.
3 Turn the Tuning control or press Mic [UP]/[DWN] to
select the Call Channel (“C”).
4 Press [MR].
• The selected frequency and related data are stored in
the Call Channel.
To also store a separate transmit frequency, continue with the
following steps:
5 Select the desired transmission frequency.
6 Press [F].
7 Turn the Tuning control or press Mic [UP]/[DWN] to
select the Call Channel (“C”).
8 Press [MR] (1s).
• The separate transmission frequency is stored in the
Call Channel.