Kenwood TM-271A - Manual (Page 37)

30
7
• Memory Channel numbers L0/U0 ~ L2/U2 {page 40}, Pr
{page 43}, and AL (Weather Alert) {page 36} (K market
models only) are reserved for other functions.
5 Turn the Tuning control or press Mic [UP]/[DWN] to
select the Memory Channel in which you want to
store the data.
6 Press [MR] to store the data to the channel.
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a pair of reception and transmission
frequencies with a non-standard offset. If you store two
separate frequencies in a Memory Channel, you can
operate on those repeaters without programming the
offset frequency and direction.
1 Store the desired reception frequency and related
data by following steps 1 to 6 given for simplex or
standard repeater frequencies {page 29}.
2 Turn the Tuning control or press Mic [UP]/[DWN] to
select your desired transmission frequency.
3 Press [F].
4 Turn the Tuning control or press Mic [UP]/[DWN] to
select the pre-programmed reception Memory
Channel in which you want to store the data.
5 Press [MR] (1s).
• The transmission frequency is stored in the memory
channel.
Note:
◆ When you recall an odd-split memory channel, “+” and “–” appear
on the display. To confirm the transmission frequency, press
[REV].
◆ Transmit offset status and reverse status are not stored in
odd-split memory channels.
RECALLING A MEMORY CHANNEL
U
SING THE
T
UNING
C
ONTROL
1 Press [MR] to enter Memory Recall mode.
• The Memory Channel last used is recalled.
2 Turn the Tuning control to select your desired
Memory Channel.
• You cannot recall an empty Memory Channel.
• To restore VFO mode, press [VFO].