Kenwood TM-271A - Manual (Page 40)

33
7
MEMORY CHANNEL TRANSFER
M
EMORY
\ VFO T
RANSFER
After retrieving frequencies and associated data from
Memory Recall Mode, you can copy the data to the VFO.
This function is useful, for example, when the frequency
you want to monitor is near the frequency stored in a
Memory Channel.
1 Press [MR], then turn the Tuning control or press Mic
[UP]/[DWN] to recall the desired Memory Channel.
• Alternatively, press [CALL] to select the Call Channel.
2 Press [F], [VFO] to copy the Memory Channel data to
the VFO.
Note:
◆ On odd-split channels, the above operation copies only the
receive frequency to the VFO (not the transmit frequency). To
copy the transmit frequency of an odd-split channel, press [REV]
before performing the transfer.
◆ You can also transfer the Program Scan memory channels
(L0/U0 ~ L2/U2), the Priority Channel (Pr), and the Weather Alert
Channel (AL) (K market models only) to the VFO.
◆ Lockout status and Memory Names are not copied from a
Memory Channel to the VFO.
C
HANNEL
\ C
HANNEL
T
RANSFER
You can copy channel information from one Memory
Channel to another. This function is useful when storing
frequencies and associated data that you temporarily
change in Memory Recall Mode.
1 Press [MR], then turn the Tuning control or press Mic
[UP]/[DWN] to recall the desired Memory Channel.
2 Press [F].
3 Select the Memory Channel where you would like the
data copied by using the Tuning control or pressing
Mic [UP]/[DWN].
4 Press [MR].