Resolution, Adjusting the print density, 9 operating an option hard disk – Kyocera ECOSYS FS-9520DN User Manual
Page 53: Reading data, 9 operating an option hard disk -32
Chapter 3 Using the Operator Panel
3-32
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Resolution
You can set the default print resolution in three ways:
300 dpi, 600 dpi and Fast 1200 mode. The clarity of printed
characters and graphics becomes sharper in this order. (The
factory setting is Fast 1200 mode.)
Press the MENU key.
Press the or key repeatedly until Print
Quality > appears.
Press the key.
Press the or key repeatedly until
>Resolution appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select Fast 1200 mode or 300 dpi, 600 dpi using the
or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Adjusting the Print Density
The print density can be adjusted in five steps: from 01 (light)
to 05 (dark). The factory setting is 03.
Press the MENU key.
Press the or key repeatedly until Print
Quality > appears.
Press the key.
Press the or key repeatedly until >Print
Density appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select the print density from five steps from 01
(light) to 05 (dark) using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
2.2.9 Operating an Option Hard Disk
By installing the option hard disk into the printer, the e-MPS
function can be used. The printer’s menu selection system al-
lows you to perform the following operations on the hard disk.
If the option hard disk is not formatted, the >Format menu
will automatically appear on the message display.
• Reading data
• Writing data
• Deleting data
• Printing of list of partitions
Reading Data
Data stored on a hard disk can be read. To read data on a hard
disk, proceed as follows.
Press the MENU key.
>EcoPrint Mode
? Off
Print Quality >
>Resolution
Fast 1200 mode
>Resolution
? Fast 1200 mode
5
6
7
8
1
2
3
4
5
6
7
8
Print Quality >
>Print Density
03
>Print Density
? 03
1
2
3
4
5
6
7
8
1