Kyocera ECOSYS FS-9520DN - Manual (Page 46)

Chapter 3 Using the Operator Panel
3-25
Press the key to select an internal font, press the
or key repeatedly until Internal appears.
To select an option font, press the ENTER key while
> Font Select > is displayed. Press the or
key repeatedly until the message display indicates
Option.This operation is possible only when option
fonts are installed in the printer.
Press the key.
The letter before the number indicates the type of
font as follows:
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until the desired
font number appears. For font numbers of the inter-
nal fonts, see
List of Fonts on page 6-1 .
When the desired font is displayed, press the ENTER
key.
Press the MENU key. The message display returns to
Ready.
Changing Type for Courier/Letter Gothic
Courier or Letter Gothic font type can be selected as Regular or
Dark. For example, to change the type of Courier, proceed as follows:
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
Press the key.
Check that Internal is displayed and press the
key.
Press the or key repeatedly until >Courier ap-
pears.
Press the ENTER key. A blinking question mark (?)
appears.
Select Regular or Dark using the or key.
Press the ENTER key.
Press the MENU key and the message display re-
turns to Ready.
Changing the Font Size
You can change the size of the default font. If the default font
is a fixed-pitch font such as Courier or Letter Gothic, the
character pitch can be changed instead of the font size.
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
>Font Select >
Internal
>> I000
Letter Description
I Internal fonts
S Soft (down load) fonts
M Fonts in an option memory card
H Fonts in a RAM disk or hard disk
O Fonts in an option ROM
Table 3-8
>>?I000
>Font Select >
Internal
3
4
5
6
7
8
Font >
>Font Select >
Internal
>>Courier
Regular
>>Courier
? Regular
Font >
1
2
3
4
5
6
7
8
9
1
2