Correcting image distortion – Kodak 3000DSV-E User Manual

Page 45

3-22

A-61371 September 2004

Correcting Image
Distortion

You can set up the scanner-printer to automatically correct any slight
image distortion that occurs during scanning.

1. Press and hold the Shift key and the Paper Selection key.

2. Select U2 in the User mode.

3. Press the Exposure Mode key to display d*. The table below shows

the amount of correction based on the setting value:

4. Press the Exposure Adjustment key (Darker or Lighter) to select the

desired setting value.

5. Press the Start key to validate the setting.

NOTE: This setting returns to the default value (d3) when the Power

switch is turned off. You can register this setting by using the
Job Program function.

Code

Setting Value

0 mm

0.5 mm

1.0 mm

1.5 mm

2.0 mm

2.5 mm

3.0 mm

3.5 mm

4.0 mm