Kodak 3000DSV-E - Manual (Page 2)

A-61371 September 2004
Safety Warnings
This section contains detailed instructions on the operation and maintenance of the Kodak 3000DSV-E Digital
Scanner-Printer. All operators should carefully read and follow the instructions in this manual.
The following section contains important information related to operator safety and may help prevent equipment
problems. Make sure you observe all of the precautions listed in this manual.
Warning symbols
• Do not modify this product, as a fire, electrical shock, or breakdown could result. If the product
employs a laser, the laser beam source could cause blindness.
• Do not attempt to remove the covers and panels, which have been fixed to the product. Some
products have a high-voltage part or a laser beam source inside that could cause an electrical
shock or blindness. The operator is only allowed to slide out/in the projection unit of the scanner.
• Only use the power cord supplied in the package. If a power cord is not supplied, only use the
power cord and plug that is specified in Power Cord Instruction. Failure to use this cord could
result in fire or electrical shock.
• Use only the specified power source voltage. Failure to do so could result in fire or electrical
shock. If you are in doubt, contact a qualified electrician.
• Do not use a multiple outlet adapter to connect any other appliances or machines. Use of a power
outlet for more than the marked current value could result in fire or electrical shock.
• Do not touch the plug of the power cord with a wet hand, as an electrical shock could result.
• Connect the plug of the power cord all the way into the power outlet. Failure to do this could result
in a fire or electrical shock.
• Do not scratch, abrade, place a heavy object on, heat, twist, bend, pull on, or damage the power
cord. Use of a damaged power cord (exposed core wire, broken wire, etc.) could result in a fire,
electrical shock or breakdown. Should any of these conditions be found, immediately turn OFF the
power switch, unplug the power cord from the power outlet, and then call your Kodak Service
Representative.
• Do not use an extension cord. Use of an extension cord could cause a fire or electrical shock.
Contact your Kodak Service Representative if an extension cord is required.
• Do not place a flower vase or other container that contains water, or metal clips or other small
metallic objects on this product. Spilled water or metallic objects dropped inside the product could
result in a fire, electrical shock, or breakdown.
• Should a piece of metal, water, or any other similar foreign matter get inside the product,
immediately turn OFF the power switch, unplug the power cord from the power outlet, and call
your Kodak Service Representative.
• If this product becomes inordinately hot or emits smoke, or unusual odor or noise, immediately
turn OFF the power switch, unplug the power cord from the power outlet, and then call your Kodak
Service Representative. A fire or electrical shock could result if you continue to use the product.
• If this product has been dropped or its cover damaged, immediately turn OFF the power switch,
unplug the power cord from the power outlet, and call your Kodak Service Representative. A fire
or electrical shock could result if you continue to use the product.
• Connect the plug of the power cord to a wall socket-outlet that is equipped with a grounding
terminal.