Kenwood HM-381MD User Manual
Page 72
HM-381MD (En)
72
Knowledge section
In case of difficulty
Action
Meaning
Displayed Message
÷ No disc is placed on the tray.
÷ An attempt is made to record digital
signal from a source while its digital copy
has been prohibited by SCMS.
÷ There is no recordable area on the disc.
÷ An attempt is made to record a 256th
track.
÷ An attempt is made to assign a title with
more characters than usable.
÷ The disc does not contain any record-
ings.
÷ The disc does not contain any tracks but
has a disc title.
÷ The TOC *1 data of the disc is being
read.
÷ The data related to editing or recording is
being written in the disc.
÷ The contents of UTOC *2 are abnormal.
÷ An attempt is made to perform editing
beyond the restrictions, for example to
erase a track which is too short.
÷ This is a message for confirming if edit-
ing can really be executed.
÷ The minidisc is write-protected.
÷ The minidisc is only for playback.
÷ This indicates some trouble.
÷ Load a disc.
÷ Switch to analog recording.
÷ Use another recordable disc.
÷ More than 256 tracks cannot be recorded
per disc.
÷ Refer to “Total number of title charac-
ters”.
÷ When playback is required, use a re-
corded disc.
÷ The disc can be used for recording with-
out any problem.
÷ This is a normal operation.
÷ This is a normal operation.
÷ Perform “ALL ERASE” operation. If this
is not possible, use another disc.
÷ Perform editing following the restric-
tions.
÷ Press the ENTER key to execute editing.
÷ Cancel the write protection.
÷ Insert a minidisc for recording.
÷ Return to normal condition is made by
switching the unit off and then on again.
NO DISC
CAN'T COPY
DISC FULL
TITLE FULL
BLANK DISC
NO TRACKS
READING
WRITING
DISC ERROR
CAN'T EDIT
?(blinking)
PROTECTED
PLAY ONLY
UNIT ERROR
MD recorder section (Displayed messages and actions to be taken against them)
p
O
8
*1All minidiscs contain a Table of Contents (TOC) in addi-
tion to sound signals. The TOC is similar to the table of
contents in a book and contains information, such as
track numbers, track length, and character information,
that cannot be rewritten.
*2In addition to the TOC, minidiscs also contain a special
User’s Table of Contents (UTOC) that contains track
number, track length, and character information, that
can be rewritten.
Memory Backup for the MD Recorder Section
The contents of the memory are not stored on the
disc if the power cord is unplugged.
If there is a power failure or if the power cord is
unplugged, the recording or editing information
(normally recorded when the minidisc is removed)
may be erased or destroyed before it is recorded on
the minidisc. Once the information has disappeared,
it can not be recovered.
After recording or editing, always remove the
minidisc to record the recording or editing informa-
tion.
US and foreign patents licensed from Dolby Laborato-
ries Licensing Corporation.