Playback of tape – Kenwood HM-381MD User Manual
Page 26
HM-381MD (En)
26
Basic section
2
2
2
2
1
1
2
2
A
push open
0
1
1
TAPE
direction
2
2
2
2
Let's put out some sound
Playback of tape
If you load a tape in the cassette deck in advance while
the power is off. pressing the TAPE key turns power
on automatically and starts the tape playback.
To stop playback
Selection of TAPE EQ.
Selection of reverse mode
To wind tape at high
speed
Start playback
1. Load a cassette tape.
1 Open the door.
2 Insert a tape and close the door.
2. Start playback.
During playback, the tape running direction changes each time the
key is pressed.
The “direction” indicators show the current direction in which the tape
advances when playback or recording is started automatically by the
one-touch operation, etc. This direction is the direction stored in memory
when the tape was last stopped.
(To change the tape transport direction, press the TAPE key (
2, 3)
during playback then press the stop key (
7).)
Transport direction indicators
Transport direction indicators
To wind tape at high
speed
To stop playback