Kodak DP2900 - Manual (Page 38)

User Guide KODAK DP2900 Digital Projector
38
Controls Menu
Video Standard
Note: If you already know the video standard used in your
geographical area, it’s often best to manually select it.
When Video standard is set to Auto, the projector attempts to pick the
video standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL-60,
or SECAM) automatically based on the input signal it receives. (The
video standard options may vary depending on your region of the
world.) The input signal for SECAM video is similar to other video
signals and cannot be automatically detected, therefore SECAM must
be chosen manually. If the projector is unable to detect the correct
standard, the colors might not look right or the image might appear
“torn.” If this happens, manually select a standard by clicking the left
or right navigation button and cycling through the standards.
Standby Time
This option lets you select how long the lamp stays on and the blank
screen is displayed when the projector enters standby mode before the
projector turns off. Select among instant, 1, 5, 10, 15 and 30 minutes
and 1 and 2 hours by clicking the left or right navigation button and
cycling through the options.
Rear Projection
When you turn Rear Projection on, the projector reverses the image so
you can project from behind a translucent screen. Highlight Rear