Kodak DP2900 - Manual (Page 25)

25
Using the Projector
This section describes how to use and make adjustments to the
projector. It also provides a reference to the keypad and remote
buttons and the options available from the on-screen menus.
Basic Image Adjustment
• Make sure you have turned on your equipment in the right order
(page 22).
• If the image doesn’t display completely, zoom the image (page 26),
adjust the height of the projector (page 26) or center the image by
adjusting its horizontal or vertical position (page 37). Be sure the
projector is at a 90 degree angle to the screen.
• If the image is out of focus, rotate the focus lens (page 26).
• If the image appears to shimmer or if it has blurry vertical bars
after you have adjusted the focus, turn Auto Image (page 36) off
and then back on to reset the automatic sync and tracking. If that
doesn’t clear up the image, turn Auto Image off and adjust the sync
(page 37) and/or the tracking (page 37) manually.
• If the colors don’t look right, check the KODAK Image Manager
settings. See “Using KODAK Image Manager” on page 43.
,PSRUWDQW7KH .2'$. ,PDJH 0DQDJHU VHWWLQJV ZRUN EHVW LI \RX VHOHFW 5HVHW
IURP WKH $GMXVW WDE HDFK WLPH EHIRUH VHOHFWLQJ DQ ,PDJH 0DQDJHU
VHWWLQJ
Or
Adjust the brightness (page 33) and the tint (page 34).
• If the computer source image is not rectangular, adjust the
keystoning (page 35).
• If the edges of the video source image appear jagged, adjust the
overscan (page 35).