Kyocera FS-1700 - Manual (Page 7)

Introduction
vi
Laser notice
This printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter for
Class I (1) laser products, and elsewhere is certified as a Class I laser product conforming to the
requirements of IEC 825-1.
Caution Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
CDRH regulations
The Center of Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser
products manufactured after August 1, 1976. Compliance is mandatory for products marketed in
the United States. A label indicating compliance with the CDRH regulations must be attached to
laser products marketed in the United States.
Ozone concentration
The printers generate ozone gas (O
3
) which may concentrate in the place of installation and cause
an unpleasant smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recom-
mend you not to install the printer in a confined area where ventilation is blocked.
The labels shown are affixed to the FS-3700+.
Similar labels are affixed to same location on the FS-1700+.
(European/Asian
countries)
(U.S.A./Canada)