Sun Microsystems Sun StorageTek SG-XPCIE20FC-NEM-Z - Manual (Page 27)

Chapter 2 Hardware Installation and Removal 11
FIGURE 2-2 Inserting the NEM Into the Chassis
7. Push the ejector levers toward each other and close the levers to secure the
NEM in its slot.
After you physically install the NEM in its slot, the Chassis Monitoring Module
(CMM) will automatically detect the presence of the NEM. The OK LED goes to
Standby blink (see
TABLE 2-3 for LED status).
8. Press the Attention button to notify the blades (host operating systems) of the
presence of the NEM.
9. Verify that the NEM is working properly.
See “To Verify NEM Status” on page 17 .