Sun Microsystems Sun StorageTek SG-XPCIE20FC-NEM-Z - Manual (Page 23)

7
C H A P T E R
2
Hardware Installation and Removal
This chapter describes the tasks required to install and remove the NEM when the
Sun Blade 8000 Modular System is in a powered-on state.
Note – If you are powering on the Sun Blade 8000 Modular System or Sun Blade
8000 P Modular System for the first time, follow the installation instructions in the
Sun Blade 8000 Series Installation Guide.
This chapter contains the following topics:
■ “Observing ESD and Handling Precautions” on page 8
■ “Installing the NEM” on page 8
■ “Configuring the NEM For Hot-Plug Operation” on page 14
■ “Verifying a Hot-Insert Operation” on page 16
■ “Replacing a NEM” on page 19