Smart Technologies Interactive Whiteboard System 600i5 - Manual (Page 94)

4. Remove all cables connected to the ECP.
5. Locate the jumper cover between the “PC” and “SE240” labels on the side of the ECP that
faces the wall.
6. Using a pair of wire cutters, cut through the two tabs on the jumper cover and remove it from
the ECP. Keep the jumper cover in a safe place.
g To remove the USB jumper switch
1. Locate the USB jumper behind the jumper cover port.
2. Using needle-nose pliers, pull the jumper from the two connection posts, and then place it on a
single post.
I
I M P O R T A N T
o Only adjust the jumper position. Do not adjust the PC/SE240 switch, which is also
accessible from this area.
o Do not discard the jumper. Discarding the jumper makes the USB deactivation difficult
to reverse.
3. Insert the USB jumper cover into the USB A port on the front of the ECP.
A P P E N D I X C
Disabling user USB access
82