Smart Technologies Interactive Whiteboard System 600i5 - Manual (Page 82)

Projector programming commands
This section documents the projector programming commands.
Projector power state controls
Your projector responds to commands only at certain power states and times.
There are five projector power states:
l
Powering (startup)
l
On (operating)
l
Cooling
l
Confirm off
l
Idle (Standby mode)
Command inventory
Your projector responds to the commands in the tables on the following pages. To see a list of valid
commands in the projector’s current power state, type ? and press ENTER.
I
I M P O R T A N T
When entering commands, ensure there is a 10 millisecond delay between characters for reliable
operation.
N
N O T E S
l
Send a command only after the projector sends a command prompt.
l
Commands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
l
Check your entries carefully before entering your commands.
l
Press ENTER after typing each command.
l
After the projector executes a command, it generates a response.
l
To prevent buffer overrun, don’t send another command until you receive the next command
prompt.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
70