Smart Technologies Interactive Whiteboard System 600i5 - Manual (Page 31)

Setting Use Notes
Network menu
Network and VGA
Out Activates the projector’s VGA Out and
RJ45 connector and network features.
Status Displays the current network status
(Connected, Disconnected or Off). The default is off.
DHCP Displays the status of the network’s
Dynamic Host Configuration Protocol
(DHCP) as On or Off. The default is on.
On enables a DHCP server on the
network to automatically assign an IP
address to the projector.
Off enables an administrator to assign
an IP address manually.
Password
Reminder E-mails the network password to the
predefined e-mail recipient. See Web page management on page
57 to set up a destination e-mail
address.
IP Address Displays the projector’s current IP
address in values between 0.0.0.0 and
255.255.255.255. To change the projector’s IP address,
use the RS-232 connector (see
Network controls on page 76) or use a
DHCP server to assign a dynamic IP
address, and then set a static IP
address using the network remote
management feature (see Remotely
managing your system through a
network interface on page 57).
Subnet Mask Displays the projector’s subnet mask
number in values between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector’s default
network gateway in values between
0.0.0.0 and 255.255.255.255.
DNS Displays the projector’s primary
domain name number in values
between 0.0.0.0 and 255.255.255.255.
MAC Address Displays the projector’s MAC address
in xx-xx-xx-xx-xx-xx format.
Group Name Displays the projector’s workgroup
name as set by an administrator
(maximum 12 characters). You can set the projector’s workgroup
name using the remote management
features (see Remotely managing your
system through a network interface on
page 57 and Remotely managing your
system through an RS-232 serial
interface on page 67).
C H A P T E R 3
Using your interactive whiteboard system
19