Swann SW244-8ML - Manual (Page 39)

SE
TUP
z SENSOR INPUT Select sensor action way between
NC(NORMAL CLOSE) or NO(NORMAL OPEN).
z ALARM Select alarm action way between High >> Low
or Low >> High.
Press + buttons on remote controller to select ETC. in SETUP menu.
ETC.
z BAUD RATE
z DATA BIT
z STOP BIT
z PARITY
Select the BAUD RATE. (Default is 9600.)
1200 → 2400 → 4800 → 9600 → 19200 →
38400 → 57600 → 115200
Baud rate means the speed of between the
devices.
Select 5~8 the DATA BIT. (Default is 8.)
Data bit means the number of data bit.
Select 1 or 2 the STOP BIT. (Default is 1.)
Stop bit means the number of stop bit
between data transfer.
Select the PARITY. (Default is No Parity.)
No Parity → Odd Parity → Even Parity.
Parity means the error check bit while the
data is transferring.
Press ID and current DVR ID number and then ENTER button on the
remote controller.
‰ How to use DVR ID
Current DVR ID
Press the number ~ button same as current DVR ID 1 DVR ID (1)