Swann SW244-8ML - Manual (Page 37)

SE
TUP
‰ Set PTZ & RS-485, EVENT, ALARM INPUT, MOTION ALARM OUTPUT and
REMOTE CONTROL in TECHNICAL SETTING menu.
Press + buttons on remote controller to select PTZ in SETUP menu.
z PTZ ID Select the PTZ ID. (0 ~ 99)
z PROTOCOL Select the PROTOCOL. (Default is Pelco-D.)
z BAUD RATE Select the BAUD RATE. (Default is 9600.)
1200 → 2400 → 4800 → 9600 → 19200 →
38400 → 57600 → 115200
Baud rate means the speed of between the
devices.
z DATA BIT Select 5~8 the DATA BIT. (Default is 8.)
Data bit means the number of data bit.
z STOP BIT Select 1 or 2 the STOP BIT. (Default is 1.)
Stop bit means the number of stop bit
between data transfer.
z PARITY Select the PARITY. (Default is No Parity.)
No Parity → Odd Parity → Even Parity.
Parity means the error check bit while the
data is transferring.
z EVENT SERVER
z EVENT TYPE
z EVENT
NOTIFICATION
TO E-MAIL
z
MAIL SERVER
z USER ID & P/W
z MAIL ADDRESS
6. TECHNICAL SETTING
NOTICE
All of settings must be the same as the PTZ camera’s settings.
The settings is different from the camera’s models. See the PTZ camera’s manual for setting of
RS-485.
PTZ & RS-485
EVENT
Press + buttons on remote controller to select EVENT in SETUP menu.
Type the EVENT SERVER domain or IP address.
Type the domain or IP address of the computer
which used for operating CMS(Central Monitoring
System) software.
If you want to receive event message on CMS
software, you must set the same port as CMS port.
Select the EVENT TYPE.
The event occurrence at the time of which it selects
to inform as the event server which it sets.
It will be available to set the time when it will
receive the event message in event type by.
Check if you want to receive event message
by E-MAIL.
Must do SETUP after check.
Type sender MAIL SERVER address.
If you do not type mail server address,
event message mail will be classified by spam.
Type the E-mail address to receive event message
mail.
Type mail account USER ID and PASSWORD.
2510
2510