Swann SW244-8ML - Manual (Page 27)

SE
TUP
1. BASIC SETTING
If you set to ‘0’ frame, recording will be disabled even though PANIC.
So recommend setting over 1 frame.
Applies same recording settings to all
cameras simultaneously.
Add Max 16 schedules, to set recording
settings of each camera separately.
Higher schedule number(No.) is applied
above all.
The factory default setting are 8 and 7
(NTSC), which means DVR records at the
speed of 7~8 frames per second. The
higher recording frame is set the more
natural video will be displayed on the
screen when you playback.
The lower recording frame is set the more
space you will save on the hard disk drive.
There are different record frame rate
settings to choose 0, 1, 2, 3, 5, 7, 8, 10, 15, 30
frame per second (NTSC).
RECORDING SCHEDULE
Press MENU to enter the SETUP menu. Press one more time to exit.
Adjustment, OSD, Sequence.
z INTERNET &
NETWORK
z PASSWORD &
PARAMETER
z SYSTEM
z DISPLAY
z BASIC SETTING Recording schedule, Camera registration,
Audio, HDD, Pre-post recording.
Network connection, Service port & DDNS,
Update server.
Password, Parameter.
z TECHNICAL
SETTING
PTZ & RS-485, Event, Alarm input, Motion
alarm output, Remote controller, Etc.
Information & Update, Date/Time,
System LOG, Shutdown.
z GLOBAL
z EACH
z FRAME SETTING
Press buttons on remote controller to select RECORDING SCHEDULE in SETUP menu. +
CAUTION
DAY
TIME
IMAGE QUALITY
REC MODE
RES.
USE
No.
Select camera No. : All or 1 ~16 camera.
Select day : Every Each Day Mon~Fri Mon~Sat Sat~Sun
Select recording time : 00:00 ~ 24:00
Select recording image quality : Normal Good Better(default) Best
Select recording mode : Time Lapse(default) Motion
Select resolution : CIF (352 × 240) D1(720 × 480)
Add schedule of EACH camera setting.
Delete schedule of EACH camera setting.
Enabled/Disabled recording schedule.
Schedule number.
SETUP