Savin SP 3300 Series - Manual (Page 23)

5.6
Note s
• Do not push the paper width guide far enough to cause the
material to warp.
• If you do not adjust the paper width guide, it may cause paper
jams.
Using manual feeder
You can manually load a sheet of print media in the manual tray if you
select Manual Feeder in the Source option from the Paper tab when you
change print settings to print a document. See the Software Section.
Manually loading paper can be helpful when you want to check the print
quality after each page is printed.
Load paper sheet-by-sheet in the manual tray, send print data to print the
first page, and press the Cancel button on the control panel to print each
following page.
1 Open the manual feed.
2 Load the paper with the side to be printed on facing up.
3 Adjust the manual tray paper width guides to the width of the paper.
Do not force too much, or the paper will bend, which could result in
a paper jam or skew.
4 When you print a document, set the paper source to Manual
Feeder and select the appropriate paper size and type in the
software application. See the Software Section.
5 Print a document.
6 Press the Cancel button.
The printer picks up the print media and prints.
7 Insert the next sheet into the manual tray and press the Cancel
button.
Repeat this step for every page to be printed.
Note
• If you do not press the Cancel button, after a pause the printer
will automatically pick the print media.
Note
• If envelopes or thick papers(163g/m2) are printed out
with wrinkles, crease or black bold lines, open the rear cover
and pull the guide of both sides down. Keep the rear cover
opened during printing.