Siemens 300 - Manual (Page 17)

17
Putting into service
Logging mobile units onto a telephone system
Before you can telephone with the mobile unit, you must first open a "logon
window" at Hicom 300 and log on the mobile unit. This is only necessary the
first time the unit is put into service!
l
Ask your Hicom 300 system administrator for the following information:
– code no. (PIN E1) of the Hicom 300 system,
e.g. "
∗∗∗∗∗
82", and check if code no. applies network-wide
– code no. (PIN E1) of the mobile unit (e.g. 6-digit)
– mobile unit call number
– system code of the mobile unit (8-digit)
l
Open the Hicom 300 logon window – at a mobile unit that is already
logged on or at a Hicom telephone with display (at the same network
node):
Code no. Enter the code no. (PIN E1) at Hicom telephone, e.g.
"
∗∗∗∗∗
82".
e.g.
∗∗∗∗∗ 82
Enter the number of the Hicom telephone also if the
code no. applies network-wide.
Enter code no.
e.g.
123
Enter the code no. (PIN E1) of the mobile unit, e.g.
"123456" – "*" are displayed instead of digits.
e.g.
Id 34567
e.g.
345
...
Enter the mobile unit call number displayed for
confirmation purposes, e.g. "34567" – the ring tone is
briefly audible. When the ring tone ceases, the Hicom
logon window is "open" for 10 minutes.
Note:
The logon window is automatically closed if the mobile unit logon procedure
is not performed within 10 minutes as described below. If this happens you
must repeat the operation.