Samsung iDCS 100 - Manual (Page 8)

iDCS 100 USER INSTRUCTIONS
TECHNICAL MANUAL PART 1 JUNE 2002
1.7
6 = EXT This option, when set, will forward calls to the external
location programmed as the forward destination after the
External Forward timer in
MMC 502 expires. In MMC 210
there is an option to allow intercom calls to forward as
well.
7 = FWD DND This option will forward all calls to the programmed
destination whenever the forwarded station goes into
DND.
8 = CFU This option, when set, will forward all calls to the
programmed destination when the programmed
destination is in another network node. Available with
enhanced version software only.
9 = CFB This option, when set, will forward calls to the
programmed destination when the forwarded keyset is
busy, when the programmed destination is in another
network node. Available in enhanced version software
only.
✱= CFNR This option, when set, will forward calls to the
programmed destination, when the programmed
destination is in another network node, if the forwarded
station does not answer a call before the forward no
answer timer in
MMC 502 expires. Available in enhanced
version software only.
ACTION DISPLAY
1. Press the transfer key followed by 102
Display shows [201] FORWARD
0:FORWARD CANCEL
2. Dial 0 – ✱ to select forward type
OR [201] FORWARD
1:ALL CALL:NONE
Press UP or DOWN to select forward type
and press RIGHT soft key to move cursor
3. Dial destination number (e.g., 201)
OR [201] FORWARD
1:ALL CALL:205
Press UP or DOWN to select destination
and press RIGHT soft key to move cursor
HOME
PAGE
Table of
Contents