Samsung iDCS 100 - Manual (Page 145)

34
CUSTOMER SET RELOCATION
This program is used to swap information associated with two stations. All
assignments such as trunk ring, station group, station COS, station speed
dial etc. will follow this program. 12 button keysets and 24 button keysets
can be exchanged. Basic 7 button keysets can be exchanged with Basic 7
button key sets. Single line stations numbers can be exchanged. If incom-
patible set types are selected the system will provide an ERROR: NO MATCH
message. 12 button and 24 button key assignments should be taken in con-
sideration when relocating these type of sets. The table below shows which
phones can be switched with each other.
NOTE: In order to use this program it must first be activated by a technician.
Please see your installing company to have this done if you wish to use this
program.
PROGRAM KEYS
UP & DOWN - Used to scroll through options.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
SPK - Used to store data and advance to next program.
HOLD - Used to clear previous entry.
ANS/RLS - Used to select ALL.
ACTION DISPLAY
1. Press TRSF 315 SET RELOCATION
Display shows EXT _ EXT
2. Enter first station number (e.g., 202) SET RELOCATION
Press RIGHT soft key to move cursor EXT 202 EXT _
3. Enter second station number (e.g., 210) SET RELOCATION
Press RIGHT soft key to enter data EXT 202 EXT 210
4. Display will return to STEP 1 SET RELOCATION
Go to STEP 2 EXT _ EXT
OR press TRSF to store and exit
programming.
HOLIDAY
This program provides the ability to set as many as 20 different holidays.
Each holiday will override the System Operating Mode for that particular
date with a programmed ring plan.
PROGRAM KEYS
UP & DOWN - Used to scroll through options.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
HOLD - Used to clear an entry.
ACTION DISPLAY
1. Press TRSF and then dial 512 RING PLAN
Display shows FOLLOW1
2. Press the right soft key to move the RING PLAN
cursor to bottom half of display FOLLOW1
3. Enter the desired ring plan (e.g., 0-6) RING PLAN
Display will return to STEP 1 FOLLOW4
4. Press UP or DOWN to change display ASSIGN HOLIDAY
to holiday assignment 01:
5. Press the right soft key to move the ASSIGN HOLIDAY
cursor to bottom half of display 01:
6. Enter a desired holiday date ASSIGN HOLIDAY
(e.g., 1225) 01:
7. Press TRSF to store and exit ASSIGN HOLIDAY
programming OR press SPK to store 01:1225
and advance to the next program
33
HOME PAGE Table of Contents Guide-Contents