Samsung SP-M305 - Manual (Page 30)

Installation and Connection 2-14
2-14 Connecting an AV device with Component output
Make sure that the AV device and your projector are turned off.
1. Connect the [PC IN] terminal on the back of the projector to the Component terminal on your AV device using a D-Sub to
Component cable (Not supplied). This cable has a D-Sub connector on one end and three RCA jacks on the other.
- For supported input signal formats, resolutions, and frequencies, see AV Timing (D-Sub) in Section 2-8, "Supported Display
Modes".
2. Connect the [ AUDIO IN (L-AUDIO-R) ] terminal on the back of the projector and the Audio out terminal on your AV device using
an audio cable (Not supplied).