beautypg.com

Establishing a connection – Siemens DataNET Hub (DNH) User Manual

Page 63

background image

2000585-001

Data Communications Setup

•••• 55

Establishing a Connection,

Continued

A password name can consist of any combination of alphanumeric char-
acters. The alphanumeric name must have a minimum of five and a
maximum of twenty characters. The DNH Communication board is
shipped from the factory with the word “password” entered as the de-
fault password name.

The user can change the password name at any time. To do this login
using the current password then type: “password stand stand”. Where
the word stand is your new password entered twice to verify that it was
properly entered.

You may log out or close the Configuration and Diagnostic program at
any time by typing logout. However, the Configuration and Diagnostic
program will automatically log you out after five minutes.

The following procedure assumes that the HyperTerminal program, re-
siding on your PC, has been configured to communicate with the DNH,
and the PC is connected to the DNH ‘A’ or ‘B’ Configuration Port.

1. Open Windows HyperTerminal program.

2. Press

↵↵

Enter twice

The following dialog box appears:

Password Format

How to Change
Password

How to Log Out

How to Log On