Siemens DataNET Hub (DNH) - Manual (Page 30)

22 •••• Installation 2000585-001
Site Wiring Requirements, Continued
Use Cable Gland wiring method. Each cable gland allows entry of one
duplex fiber cable.
Cable Type: Duplex fiber, 62.5/125 micron.
Connections: Type ST fiber connectors. Connect these to the appropri-
ate transmitter and receiver ports for the respective channel.
Use approved flexible non-metallic conduit. Conduit may contain multiple
cables. Conduit may contain multiple. This method is suitable for CE in-
stallations.
Cable Type: Duplex fiber, 62.5/125 micron.
Connection: Type ST fiber connectors. Connect these to the appropriate
transmitter and receiver ports for the respective channel.
The wiring method and cable type is dependent upon the site require-
ments.
See Page 23,CE Installations
Use approved Metal Conduit wiring method. Conduit may contain multi-
ple cables. Adhere to all Federal and local electrical code requirements.
Cable Type: Use non-shielded Category 5 cable, see Table 2-1.
Connection: Connect to RJ-45 connector on ‘A’ HUB –half board (left
one in wall mount enclosure, left one in rack mount unit as faced from
front of unit.)
Use Cable Gland wiring method:
Cable Type: Use shielded Category 5 cable and connectors.
Connection: Connect to RJ-45 connector on ‘A’ HUB –half board (left
one in wall mount enclosure, left one in rack mount unit as faced from
front of unit). Connect the shield to the cable gland ring.
Use approved Non-metallic conduit wiring method.
Cable Type: Use unshielded Category 5 cable and connectors, see Ta-
ble 2-1.
Connection: RJ-45 connector on ‘A’ HUB (left one in wall mount enclo-
sure, left one in rack mount unit as faced from front of unit.)
Cenelec Zone 1 or Zone 2
Rated Areas
Non-Hazardous Areas or
Rack Mounting
Ethernet Communica-
tion Links
CE Installations
NEC Div 2 or Non-
Hazardous Areas
Cenelec Zone 1 or Zone 2
Rated Areas
Non-Hazardous Areas or
Rack Mounting