Standard Horizon MAX CPF180I - Manual (Page 57)

CPF180i and CPF300i Page 59
7. CREATING MARKS
Definitions:
MARK
Can be a stand alone position or be linked to a Route. A Mark is place on the Chart page using
[MARK] or by entering in information in the MARK/WAYPONTS List NEW MARK selection.
WAYPOINTS
Always linked to a Route. Are placed on the Chart page using [ROUTE].
NOTE
The difference between a Mark and a Waypoint is
a. When a Route is created using WAYPOINTS and the ROUTE is deleted the WAYPOINTs are
also deleted.
b. If a Route is created using MARKS and the ROUTE is deleted the MARKs remain.
7.0 CREATING A NEW MARK USING THE CHART PAGE
1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the Cursor and a popup window
is shown with the exact Lat/Lon of the Mark.
3. If the position is incorrect on the CPF180i press [ENT], select EDIT using the
ShuttlePoint knob and press [ENT]. On the CPF300i, press [E
DIT
] that will allow you to
change the position, Mark name, icon type and color of the icon.
Vessel location
Mark placed under Cursor
Lat/Lon of Mark, DST/BRG
from vessel location
2
1
4
ONLY for CPF300i
Press Soft Key to show
, to edit,
to move or to delete Mark
the
Marks/Waypoint List
5
ONLY for CPF180i
Press [ENT] to delete, to move,
to edit a Mark or to show the
Marks/Waypoint List (Directory)
3
1
2
4
5
3
Figure 7.0 - Mark creation
NOTE
After entering in all the Marks it is a good practice to back up the points to an User C-CARD. Refer
to Section 11.
7.1 EDITING A MARK
If a Mark has previously been created and you wish to Edit it, move Cursor over the top of
the Mark.