Standard Horizon MAX CPF180I - Manual (Page 28)

Page 30 CPF180i and CPF300i
pressed, a popup window will be shown allowing you to select to start navigating to the
position of the cursor, Mark or Route.
To stop navigation to a point, press [GO TO] and select Stop on the pop-up window.
The MARK key
Places a Mark under the ships position when in Home Mode, or when the cursor is shown will
place a Mark under the location of the cursor.
The ROUTE key
When pressed places a Waypoint. Succeeding presses place more Waypoints to form a Route.
The PWR key and Lamp/Contrast
Press and hold [PWR] to turn the GPS Chart Plotter on or off. Once on, press [PWR] to show
the Contrast and Lamp popup window.
The MOB key
When pressed the GPS Chart Plotter automatically places a Mark on the Chart page under
the boats position and all navigation is towards the position of the MOB Mark to aid in the
rescue or a person that may have fallen overboard.
The FIND key
When pressed shows the Find Services & More Menu (see Chapter 4) and also information
on the selected point.
3.0.0 The CPF300i Soft Keys
The 6 keys in the bottom of the front panel (hereinafter named Soft Keys) have different
functions associated depending on the software: their labels are shown on the screen
immediately above the soft keys (the user can customize the function associated with each
soft key).
The Soft Keys
These keys allow quick selection to the many pages the GPS Chart Plotter has. These keys
can be customized to your preference, however from the factory the keys are preprogram-
med with the following pages. From left to right VIDEO, NAV, HIGHWAY, CELEST, CHART,
LIST. Press any of the keys and you will see popup windows above the keys. To goto a
specific page press the key with the desired popup window. The popup windows will
automatically disappear if a key is not pressed or can be removed by pressing [CLR].
3.1 GETTING STARTED
The Getting Started section will take you through the frequently used operations and assist
you to customize the look of the GPS Chart Plotter.
3.1.0 Power On, Off and ShuttlePoint knob operation
1. Press and hold [PWR] until the display shows the start-up page. To turn off, press and
hold [PWR] until the display turns off.
2. When the power is first turned on two pages the start-up page (see the following picture)
and the Caution page are briefly shown before the GPS Status page.