Standard Horizon MAX CPF180I - Manual (Page 50)

Page 52 CPF180i and CPF300i
3. Move the ShuttlePoint knob to highlight PLACE NAMES SIZE and press [ENT] or move
the ShuttlePoint knob to the right.
4. The menu now shows two selections, STANDARD, MEDIUM or LARGE.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.2 Perspective View
The Chart page may be show in a perspective (fly over) or normal mode during navigation.
This function allows setting the panoramic View of the chart. As the upper side of the map
is more compressed than the lower side, a wider map area is visible. The perspective view
allows showing more chart information immediately ahead and around the cursor.
Figure 6.0.2 - Perspective View
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight PERSPECTIVE VIEW and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows two selections, ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the chart page is shown.
6.0.3 Dynamic Nav-Aids
This function allows the blinking of the Nav-Aids to be turned On or Off. The blink period and
color of each Nav-aid is read from the Nav-Aid attributes stored on the optional C-MAP B
Y
J
EPPESEN
C-Card. When the ship is inside the Nav-Aid nominal range, the light of the Nav-Aid
will start blinking. When Dynamic Nav-Aids option is set to On, when the flashing light is Off,
or when fix position is out of the sector, the light color is displayed by using a faint light color.
To activate this function follow the procedure below:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight DYNAMIC NAV-AIDS and press [ENT] or move