Map functions – Standard Horizon MAX CPF180I User Manual

Page 49

CPF180i and CPF300i

Page 51

6. MAP FUNCTIONS

6.0

MAX FUNCTIONS MENU

1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move

the ShuttlePoint knob to the right. The MAX Functions menu appears on the screen:

Figure 6.0 - Map Functions Menu

The available Functions are described in the following.

6.0.0 Zoom Type

Zoom Type refers to the chart scale selection. It has two options: Standard (default) or Flexi-
Zoom. When Zoom Type is set to Flexi-Zoom, a short [ZOOM IN]/[ZOOM OUT] push
causes a change of chart level, while a long [ZOOM IN]/[ZOOM OUT] push (press and hold)
causes an expansion or compression of the chart image, without a chart level change.
By pressing [ZOOM IN]/[ZOOM OUT] a popup window is displayed on a corner of the chart
screen. The window shows the current zoom factor: Normal is the original chart level (1:1
scale), Over-Zoom x2, x4, x16, x32, Under-Zoom x1/2, x1/4.

To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move

the ShuttlePoint knob to the right.

3. Move the ShuttlePoint knob to highlight ZOOM TYPE and press [ENT] or move the

ShuttlePoint knob to the right.

4. The menu now shows two selections, STANDARD or FLEXI-ZOOM.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint

knob to the left a few times.

6.0.1 Place Names size

On MAX charts it is possible to set the size of all names drawn on the charts, selecting
between Standard, Medium and Large size.

the ShuttlePoint knob to the right.

This manual is related to the following products:

MAX CPF300I