Standard Horizon MAX CPF180I - Manual (Page 122)

Page 124 CPF180i and CPF300i
17.11.4 A-Scope
Shows the real time display of the echo from the bottom.
17.12 TRANSDUCER SETUP
This menu allows you to calibrate the speed through the water, water temperature and the
keel/prop offset of the transducer.
Figure 17.12 - Transducer Setup menu
17.12.0 Keel Offset
The keel offset can be set to cause the Fish Finder to display an offset depth below the keel
or the actual water depth from the surface. To setup to show the depth below the keel, enter
a negative depth value or a positive depth to show offset from the transducers face to the
water surface.
17.12.1 Calibrate Water Speed
Used to calibrate the Water Speed readings from the transducer. Adjustment can be made
from -10% to +10%.
17.12.2 Calibrate Water Temp
Used to calibration on the Water Temperature sensor in the transducer.