Sprint Nextel SPRINT PCS VISION SCP-2400 - Manual (Page 245)

Section 4A: Important Safety Information 229
Impor
tan
t
Saf
ety Inf
orma
tion
Knowing Radiofrequency Safety
The design of your phone complies with updated NCRP standards described
below.
In 1991–92, the Institute of Electrical and Electronics Engineers (IEEE) and
the American National Standards Institute (ANSI) joined in updating ANSI’s
1982 standard for safety levels with respect to human exposure to RF
signals. More than 120 scientists, engineers and physicians from
universities, government health agencies and industries developed this
updated standard after reviewing the available body of research. In 1993,
the Federal Communications Commission (FCC) adopted this updated
standard in a regulation. In August 1996, the FCC adopted hybrid standard
consisting of the existing ANSI/IEEE standard and the guidelines published
by the National Council of Radiation Protection and Measurements (NCRP).
Body-Worn Operation
To maintain compliance with FCC RF exposure guidelines, if you wear a
handset on your body, use the Sprint supplied or approved carrying case,
holster or other body-worn accessory. If you do not use a body-worn
accessory, ensure the antenna is at least 1.9 centimeters from your body
when transmitting. Use of non-Sprint approved accessories may violate
FCC RF exposure guidelines.
For more information about RF exposure, visit the FCC Web site at
www.fcc.gov.
Specific Absorption Rate (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy
absorbed in the head of a user of a wireless handset.
The SAR value of a phone is the result of an extensive testing, measuring
and calculation process. It does not represent how much RF the phone
emits. All phone models are tested at their highest value in strict laboratory
settings. But when in operation, the SAR of a phone can be substantially
less than the level reported to the FCC. This is because of a variety of factors
including its proximity to a base station antenna, phone design and other
factors. What is important to remember is that each phone meets strict
federal guidelines. Variations in SARs do not represent a variation in safety.
All phones must meet the federal standard, which incorporates a
substantial margin of safety. As stated above, variations in SAR values
between different model phones do not mean variations in safety. SAR
values at or below the federal standard of 1.6 W/kg are considered safe for
use by the public.
SCP_2400 UG-P127_242.qxd 06.4.13 9:12 AM Page 229