SMC Networks 100 - Manual (Page 18)

A
BOUT THE
T
IGER
S
WITCH
100
1-4
Status LEDs
The LEDs, which are located on the front panel for easy viewing,
are shown below and described in the following table.
Figure 1-4. Port and System LEDs
Port and System Status LEDs
LED Condition Status
Power On Switch is receiving power.
RPU On Redundant power is on, and the RPU is in
backup or active mode.
Off Redundant power is off or has failed.
Mgmt On Agent is operational.
VF-45 Ports
Link On Port has established a valid network
connection.
Green Valid 100 Mbps connection.
Flashing Port has been partitioned due to an
abnormal network condition, or manually
disabled.
Act* Flashing Traffic is passing through the port.
FDX* On Port is operating at full duplex.
Off Port is operating at half duplex.
FC* On Flow control enabled.
* Use the Mode Select button to select the LED display mode.
1
Status
Activity
U