SMC Networks 100 - Manual (Page 17)

A
BOUT THE
T
IGER
S
WITCH
100
1-3
Management Options
This switch contains a comprehensive array of LEDs for
“at-a-glance” monitoring of network and port status. It also
includes a Network Management Module that allows the entire
stack to be managed in-band via SNMP or RMON (Groups 1, 2, 3
and 9) protocols, with a Web browser, or remotely via Telnet. The
switch also provides a serial port on the rear panel for out-of-band
management.
Note: Only one Network Management Module must be installed
in the stack for the current firmware release.
Description of Hardware
100BASE-FX VF-45 Ports
These ports are VF-45 multimode fiber ports that can be connected
to workstations and servers with 62.5/125 micron or 50/125 micron
multimode fiber cable.
Each of these ports support half- and full-duplex operation at 100
Mbps. Note that 100BASE-FX ports do not support
auto-negotiation of duplex mode, so this has to be configured
manually. However, the ports do support IEEE 802.3x
auto-negotiation of flow control, so the switch can automatically
prevent port buffers from becoming saturated.