Sanyo LC-2430 - Manual (Page 23)

1
Press and hold MEMORY for about 2 seconds
until Memory Store is displayed.
A beep sounds.
2
Use or , or enter a two-digit number
(01–20) to select the memory location where you
want to store the number.
3
Press INTERCOM/SELECT.
The following screen appears and a cursor flashes
indicating that you can now enter the name.
If the following screen appears, the selected location
is already occupied. Then you can either change the
entry in this location, clear the location, or select
Go Back to choose another location.
E19
#/ 1
DELETE/SCAN
TONE/ / 0 *
REDIAL/PAUSE
Memory Store
01
02
Store Name
Edit Memory07
Delete Memory07
Go Back
4
Use , , , or DELETE/SCAN to enter the name.
The name cannot exceed 13 characters.
• Use or to scroll through the character menu. It contains upper and lower
case letters and various characters.
• Use and to move the cursor to the desired location.
• Press briefly DELETE/SCAN to delete a character.
• Press and hold DELETE/SCAN to delete all numbers and characters at once.
DIRECTORY/
SPEED-DIAL
In memory store operation,
you must press a key within
20 seconds or the phone will
return to standby. If you return
the handset to the base, it will
return to standby, too.
Note:
Using the handset directory
Storing names/numbers
The handset and base each has its own memory for storing phone numbers. The handset
directory can store 20 names/numbers, while the base speed-dial memory holds up to
10 numbers.
Telephone numbers stored in either the handset directory or base memory can be dialed
using just a few key strokes.
CLT2430 5th 8/9 8/10/00 4:29 PM Page 23