Siemens A30853 - Manual (Page 43)

Programming the telephone settings
35
kap01.fm5 27.11.98 Profiset 30isdn engl.: A30853-X300-B107-1-7619
Tariff unit factor
Before you switch on the charge meter, you should enter
the tariff unit factor, i.e. the costs calculated by your net-
work operator for each call charge unit.
Activating/deactivating the display of charge/call time of the active call
If the display of charge/call time for the active (current) call
is activated, the display alternates between the call
number and the call charge (if incurred)/call time.
Enter 0 or 1 to deactivate or activate the display of charge:
● ”0“ Display of charge /call time of the active call is
deactivated
● ”1“ Display of charge /call time of the active call is
activated
In the as-supplied condition, the display of charge/call
time of the active call is activated.
T
Enter the call number for call forwarding.
S
Save the setting.
The call charges incurred in connection with call
forwarding (e.g. car telephone/mobil telephone)
are not displayed on the Profiset 30isdn nor reg-
istered on the summation meter.
The caller only pays for the connection between
his or her phone and the initial destination; the
remainder of the connection must be paid for by
the party who has activated call forwarding.
a
Handset is on-hook.
S15 Start the programming procedure.
T
Enter the password if necessary.
T
Enter the tariff unit factor.
S Save the setting.
Note:
Enter the number of three decimal places for
the tariff unit factor.
a Handset is on-hook.
S16 Start the programming procedure.