Siemens A30853 - Manual (Page 33)

Programming keys on the telephone
25
kap01.fm5 27.11.98 Profiset 30isdn engl.: A30853-X300-B107-1-7619
Programming keys on the telephone
Programming the destination dialling keys
Each Destination dialling key (at the top, left to the label-
ling card ➔ page III) can be programmed with a frequently
used call number (up to 24 digits)
If a Destination dialling key has already been assigned,
the call number is displayed by pressing this key.
You can cancel a programming procedure without making
any changes by pressing the Disconnect key.
If you press the Number redial key, you can also program
the second Destination dialling key without having to exit
the programming procedure.
Programming the speed dialling keys
You can also program the digit keys 0 to 9 with frequently
used call numbers (up to 24 digits).
If a digit key has already been assigned with a speed dial-
ling number, the call number is displayed by pressing first
the speed dialling key and then the digit key.
a
Handset is on-hook.
S10 Start the programming procedure.
T
Enter the password if necessary.
z
Press the Destination dialling key.
T
Enter the call number.
W
Press the Number redial key in order to be able to
program the second Destination dialling key with a call
number.
z Press the second Destination dialling key.
T
Enter the call number.
S
Destination dialling numbers are stored.
You can use the labelling cards supplied to note
the names of the users next to the associated
keys, for example (➔ page 41).