Siemens A30853 - Manual (Page 36)

Programming the telephone settings
28
kap01.fm5 27.11.98 Profiset 30isdn engl.: A30853-X300-B107-1-7619
Programming the telephone settings
Nearly all settings of your telephone (except parking a call,
input of the connection code and checking the settings of
the telephone) can only be programmed with the handset
on-hook (idle mode).
Programming procedures are started and exited with the
Programming key. A successful programming procedure
is concluded with a positive confirmation tone (➔ page
43). An unsuccessful programming procedure is conclud-
ed with a negative confirmation tone (➔ page 43).
A programming procedure can be cancelled at any time
without making any changes via the Disconnect key.
A programming procedure is automatically cancelled if no
key has been pressed for longer than 1 minute.
When entering digits (e.g. the input of the MSN) the digit
entered last can be deleted via the Minus key.
Password
You can define a password to protect against unauthor-
ized settings on your telephone. The password is a 4-digit
secret number. The following telephone functions can be
set without entering the password:
● Handset volume
● Ringer volume
● Ringer melody
● Park and resume a call
● Display of own call number
● Call waiting
All the other settings can only be activated after the pass-
word has been entered correctly.
All password-protected settings (except restoring the as-
supplied condition) are freely accessible in the as-sup-
plied condition (PIN 0000). Therefore, you should program
your individual password.
When you are entering the password, the digits you enter
are represented on the display as symbols only, for secu-
rity reasons.
a
Handset is on-hook.
S20 Start the programming procedure.
T
Enter the previous password.
T
Enter the new password twice (one after the other).
S
The new password is saved.