Sun Microsystems Sun Quad - Manual (Page 43)

Appendix B Configuring the Quad FastEthernet Device Driver Parameters 29
Reporting the Link Partner Capabilities
TABLE B-8 describes the read-only link partner capabilities.
If the link partner is not capable of auto-negotiation (when lp_autoneg_cap is 0)
the information described in TABLE B-8 is not relevant and the parameter value = 0.
If the link partner is capable of auto-negotiation (when lp_autoneg_cap is 1) then
the speed and mode information is displayed when you use auto-negotiation and
get the link partner capabilities.
TABLE B-8 Read-Only Link Partner Capabilities
Parameter Values Description
lp_autoneg_cap 0
1 = No auto-negotiation
= Auto-negotiation
lp_100fdx_cap 0
1 = No100Mbit/sec full-duplex transmission
= 100Mbit/sec full-duplex
lp_100hdx_cap 0
1 = No 100Mbit/sec half-duplex transmission
= 100Mbit/sec half-duplex
lp_10fdx_cap 0
1 = No 10Mbit/sec full-duplex transmission
= 10Mbit/sec full-duplex
lp_10hdx_cap 0
1 = No 10Mbit/sec half-duplex transmission
= 10Mbit/sec half-duplex