Forcing network speed between 10 mbps and 100 mbps, Type, At the ok prompt type – Sun Microsystems Sun Quad User Manual
Page 30: Reboot your system
16
Sun Quad FastEthernet PCI Adapter Installation and User’s Guide • August 1997
Forcing Network Speed Between 10 Mbps and 100
Mbps
1. At the
ok
prompt, use the
show-devs
command to list the system devices.
You should see the full path names of the
qfe
devices, similar to the example below:
2. Type:
3. Type the following, pressing the Return key at the end of line
0
:
Note –
If you already have commands in NRAM, append these lines to the end of
the file.
4. Press the Control-C keys after typing (full path name of a
qfe
device).
You will need to perform Steps 2 to 4 to set the network speed for each
qfe
channel.
Note –
In the above example, the speed is forced to 10 Mbps. To force the speed to
100 Mbps, replace 10 with 100.
5. At the
ok
prompt type:
6. Reboot your system.
See Appendix C, “Configuring the Quad FastEthernet Device Driver Parameters,”
for more information on forcing network speed.
/pci@1f,2000/pci@2/SUNW,qfe@0,1
/pci@1f,2000/pci@2/SUNW,qfe@1,1
/pci@1f,2000/pci@2/SUNW,qfe@2,1
/pci@1f,2000/pci@2/SUNW,qfe@3,1
ok nvedit
0: probe-all install-console banner
1: apply transfer-speed=10
(full path name of a
qfe
device)
ok nvstore
ok setenv use-nvramrc? true