Failed to install the usb driver (windows 98) – Sharp AJ-2000 User Manual
Page 49
47
Troubleshooting
Failed to Install the USB Driver (Windows 98)
If the printer is connected to your computer by USB cable, you must install the USB driver.
If the "Add New Hardware Wizard" window does not appear while the printer and your computer are connected
to each other and both powered on, confirm that the USB port is available following the steps below.
1111
Click the "Start" button, select "Settings", and then
click "Control Panel".
2222
Double-click the "System" icon and click the
"Device Manager" tab.
The last item listed in the Device Manager should be
"Universal serial bus controller".
3333
Click the (
) icon beside the "Universal serial bus
controller".
Two items will display, your Controller chipset type and
Root Hub. If these items appear, you can use USB port. If the
"Universal serial bus controller" shows a yellow
exclamation point or does not appear, you must check your
computer manual for USB troubleshooting or contact your
computer manufacture.
4444
After the USB port becomes available, install USB
driver referring to "INSTALLING THE USB DRIVER
(Windows 98)" in the Setup Guide and Operation
Manual.