Paper will be fed to the printer from the bypass tray. Only one sheet can
be loaded into the bypass tray. To load paper into the bypass, place the
paper into the tray against the guide and press the paper button.

When printing one page:
Load paper into the bypass then start printing from your computer. If
paper is not loaded before printing is started, the paper lamp on the
printer will blink and the message "Please set a sheet of paper on
bypass" will appear on the screen of the computer.

When printing more than one page:
Repeat as above for each page.

! The document size must be smaller than the selected

(loaded) paper. If not, printing will occur over the edge of
the paper causing the machine to become internally dirty.

! Ledger, A3, or B4 sized paper can not be loaded in this

printer. The print image should be reduced by the "Fit To
Paper Size" or "Zoom[%]" setting.

"N-Up Printing", "Fit To Page", and "Zoom[%]" settings are
not available when you select "COM10", "DL", "C6",
"Invitation A2", "Japanese Hagaki", "Banner Letter", or
"Banner A4" sized paper.

Size

8.5" x 11"

8.5" x 14"

7.25" x 10.5"

210mm x 297mm

148mm x 210mm

8.5" x 11"

210mm x 297mm

4.125" x 9.5"

4.375" x 5.75"

110mm x 220mm

114mm x 162mm

3" x 5"

4" x 6"

5" x 8"

105mm x 148mm

100mm x 148mm

Min. : 3.00" x 5.00" (76.2mm x 127.0mm)
Max. : 11.69" x 17.00" (297.0mm x 431.8mm)

Paper

Letter

11" x 17"

Ledger

Legal

Executive

297mm x 420mm

257mm x 364mm

182mm x 257mm

Banner Letter

Banner A4

COM10

Invitation A2

Index card 3" x 5"

Index card 4" x 6"

Index card 5" x 8"

Japanese Hagaki

Custom

If the "Tray" is selected from this tab and paper is placed in
the bypass tray, the paper in the bypass tray will be fed first,
and then paper will be fed from the paper tray.

Make sure to insert "Banner Letter" and "Banner A4"
through the bypass tray. Max. 5 sheets of banner paper can
be set to the bypass tray. Make sure that your application
supports Banners when you intend to print onto Banners.