Sun Microsystems Ethernet Device Driver none - Manual (Page 34)

26 Platform Notes: The hme Fast Ethernet Device Driver—May 1996
4
These parameter values, described in Chapter 3, are applicable to all SUNW,hme
devices on the system. Refer to Table 3-2 on page 11 through Table 3-8 on
page 16 for parameter descriptions. For example:
▼ To set the
ipg1 to 10 and ipg2 to 5 when you reboot
1. Become superuser.
2. Add the following lines to the /etc/system file:
3. Save the /etc/system file.
4. Save all files and exit all programs. Exit the windowing system.
5. Reboot the system by typing init 6 at the # prompt.
The system is halted and then rebooted.
adv_100T4_cap hme_adv_100T4_cap
adv_100fdx_cap hme_adv_100fdx_cap
adv_100hdx_cap hme_adv_100hdx_cap
adv_10fdx_cap hme_adv_10fdx_cap
adv_10hdx_cap hme_adv_10hdx_cap
lance_mode hme_lance_mode
ipg0 hme_ipg0
set hme:hme_ipg1 = 10
set hme:hme_ipg2 = 5
Table 4-1 Setting Variables in the /etc/system File (Continued)
Parameter Variable