Sun Microsystems Ethernet Device Driver none - Manual (Page 21)

Parameter Definitions 13
3
Table 3-4 defines the lance_mode and ipg0 parameters.
Operational Mode Parameters
Table 3-5 describes the operational mode parameters and their default values.
1. The default value is 16 nibble-times, which is 6.4 microseconds for 10 Mbps and 0.64 microseconds for
100 Mbps.
Table 3-4 Parameters Defining lance_mode and ipg0
Parameter Values Description
lance_mode 0
1 lance_mode disabled
lance_mode enabled (default)
ipg0 0-31
1
Additional IPG before transmitting a
packet (after receiving a packet)
Table 3-5 Operational Mode Parameters
Parameter Values Description
adv_autoneg_cap
0
1
Local transceiver capability advertised by the hardware
= Forced mode
= Auto-negotiation (default)
adv_100T4_cap
1
0
1
Local transceiver capability advertised by the hardware; read/write parameter
= Not 100BASE-T4 capable
= 100BASE-T4 capable
adv_100fdx_cap
1
0
1
Local transceiver capability advertised by the hardware; read/write parameter
= Not 100Mbit/sec full-duplex capable (default)
= 100Mbit/sec full-duplex capable
adv_100hdx_cap
1
0
1
Local transceiver capability advertised by the hardware; read/write parameter
= Not 100Mbit/sec half-duplex capable
= 100Mbit/sec half-duplex capable (default)