Star Micronics LC-100+ User Manual
Page 37
EDS Mode Settings
29
BANK C
Switch 1: Print Mode
Selects Draft (ON) or NLQ (OFF) as the print mode. NLQ (OFF) provides near
letter quality output, while Draft (ON) provides draft quality. Draft quality
printing may be less attractive than near letter quality, but the printing operation
is faster.
Switch 2: Printable Area
Selects Type-A (OFF) or Type-B (ON) as the printable area. Type-A (OFF)
causes the print area to start 1/6-inch from the top of the paper and end 1/4-inch
from the bottom of the paper. Type-B (ON) causes the print area to start one
inch from the top of the paper and end 1/4-inch from the bottom of the paper.
Switches 3, 4, 5: Print Pitch
Turn these switches on or off to form the pattern that matches the print pitch
setting you want to make.
Switch 6: Quiet
When the Quiet Mode is enabled (OFF), the printer prints with less noise than
normal printing. Though the Quiet Mode prints more quietly, it also takes
considerably longer than normal printing.
Print Pitch
SW3
SW4
SW5
10cpi
ON
ON
ON
12cpi
OFF
ON
ON
17cpi
ON
OFF
ON
20cpi
OFF
OFF
ON
Proportional 10cpi
ON
ON
OFF
Proportional 12cpi
OFF
ON
OFF
Proportional 17cpi
ON
OFF
OFF
Proportional 20cpi
OFF
OFF
OFF