Star Micronics LC-100+ - Manual (Page 28)

20 Control Panel Operations
Micro feed
Use the following operation to feed the paper in very small increments. This
makes it possible to align the print head exactly where you want it.
❏
Make sure the printer is off-line ( ON LINE indicator is not lit).
❏
While holding down ON LINE , press PAPER FEED to feed the paper
forward or PITCH to feed the paper backward.
Setting the top of form position
The current position of paper loaded in the printer is automatically set as the top
of the page whenever you turn power on. You can also use the following
procedure at any time to specify a different position as the top of the page.
❏
Make sure the printer is off-line ( ON LINE indicator is not lit).
❏
Use the micro feed operations (see above) to move the paper so that the
print head is located where you want the new top of form position to be.
❏
While holding down PITCH , press PAPER FEED .
The printer will beep once to indicate that a new top of form position has
been set.
Tear-off function (fanfold paper)
This procedure feeds fanfold paper to a position where it can be torn off easily.
❏
Check to make sure that the printer is on-line.
❏
Press the FONT button to perform the long tear-off operation, or press the
PITCH button to perform the short tear-off operation.
The long tear-off operation causes the paper to be fed automatically so the
tear assist edge of the printer cover is aligned with the paper’s next
perforation.
The short tear-off operation causes the paper to be fed automatically so the
tear assist edge of the printer cover is located just below the last line printed
on the paper.
❏
Pull the paper against the tear assist edge to tear it off.