Star Micronics LC-100+ - Manual (Page 34)

26 Using the EDS Mode
Printing the current switch settings
❏
To print the current EDS switch settings while in n the EDS Mode, press
and hold the control panel’s
ON LINE button and then press the PAPER
FEED button. Asterisks on the printout show whether a switch is turned on
or off.
Exiting the EDS Mode
❏
To save EDS settings you have made and exit the EDS Mode, press the ON
LINE button.
EDS Mode Settings
The following details all of the settings you can program in the EDS Mode. You
can print out a detailed overview of all the settings by performing a short test of
the printer (page 48).
BANK A
Switch 1: Emulation
Selects Standard emulation (ON) or IBM emulation (OFF). Standard emulation
causes the printer to act like the Epson ESC/P (9-pin), while IBM emulation
makes it act like the IBM Proprinter III.
Switch 2: Character Table
The function of this switch depends on whether you are using IBM or Standard
emulation.
Emulation
Switch 2
Setting
Description
Standard
ON Graphics: IBM Character Set #2
OFF Italics: Italic character table used
IBM
ON IBM Character Set #2
OFF IBM Character Set #1